In order to install the Rotary Axis:
- Slide the base into the main dovetail slot of the Fixture Plate and tighten locking screw (choose one side to tighten, and loosen the opposite side).
- Plug the cable into the front connector of the electronics cabinet and tighten connector screws.
The axis is 'A' by default, and can be accessed immediately from the controller. (Start with the "Home A" button)
Note: there was wiring change starting at Machine Number 37. If you have a machine before that, you MUST swap the green and blue wires of the cable that go from the control board to the Dsub connector (correct sequence is Red Blue Green Black):