Issue |
Cause |
Guide |
Can't connect to machine |
Network issues |
|
"Probe already triggered..." error or Z axis stuck very high |
Probe retraction failure |
|
Turret crashed into the bed |
Offsets (3.3 - Understanding Offsets - Workpiece and Tool) |
|
Filament won't extrude |
Jammed or incorrectly installed extruder |
|
Filament cabinet won't turn on |
Setpoint incorrect |
|
Blobs on the outside of a multi-material print |
Cleaning station not calibrated or slice settings may need adjustment |
|
Turret is not properly latching |
Lock locations may be incorrect due to damaged limit switch, U position can be adjusted in "Tprime#.g" and "Tpre#.g". Latch mechanism can also be lubricated. |
|
Error: Attempt to move when VIN is not in range |
Emergency stop is engaged |
|
Fans aren't turning on, cleaning station not working |
24V fuse is likely blown |
|